Skip to main content
Version: 1.14

Audit Scanner

Beginning with version v1.7.0, Kubewarden has a new feature called "Audit Scanner". A new component, called "audit-scanner", constantly checks the resources declared in the cluster, flagging the ones that do not adhere with the deployed Kubewarden policies.

Policies evolve over the time: new ones are deployed and the existing ones can be updated, both in terms of version and configuration settings. This can lead to situations where resources already inside of the cluster are no longer compliant.

The audit scanner feature provides Kubernetes administrators with a tool to consistently verify the compliance state of their clusters.

Installation​

The audit scanner component is available since Kubewarden v1.7.0. Therefore, make sure you are installing the Helm chart with app version v1.7.0 or higher.

  1. Install the kubewarden-crds Helm chart. The chart install the needed PolicyReport CRDs by default.

    helm install kubewarden-crds kubewarden/kubewarden-crds
    caution

    To store the results of policy reports, you need to have the PolicyReport Custom Resource Definitions (CRDs) available. If the necessary PolicyReport CRDs are already in the cluster, you cannot install them using the kubewarden-crds chart. In such case, you can disable the installation of PolicyReport CRDs by setting installPolicyReportCRDs to false in the chart. This means that the Kubewarden stack will not manage those CRDs, and the responsibility will be with the administrator.

    See more info about the CRDs at the policy work group repository

  2. Install the kubewarden-controller Helm chart.

    helm install kubewarden-controller kubewarden/kubewarden-controller
    note

    The audit scanner is enabled by default. If you want to disable it, set the auditScanner.enable=false.

    For more information about the installation of Kubewarden see the Quick Start guide

By default, the Audit Scanner is implemented as a Cronjob that will be triggered every 60 minutes. You can adjust this and other audit scanner settings by changing the kubewarden-controller chart values.yaml.

See here more information about the Audit Scanner.

Policy Reporter UI (optional)​

The kubewarden-controller chart comes with a subchart of the Policy Reporter. It is disabled by default, and can be enabled by setting auditScanner.policyReporter=true. The values of the Policy Reporter subchart are exposed under the policyReporter key of the kubewarden-controller values.

This will install only part of the Policy Reporter upstream chart, the UI, which provides a visualization of the PolicyReports and ClusterPolicyReports in cluster. See here more information about the Policy Reporter UI.

By default, the Policy Reporter UI is only exposed as a ClusterIP service with name kubewarden-controller-ui in the namespace where the kubewarden-controller chart was installed.

Ingress​

Users can provide their own Ingress configuration, or enable an Ingress via the subchart configuration (see the ingress config of the UI subchart here).

See this example of an Ingress configuration via the subchart:

auditScanner:
policyReporter: true
policy-reporter: # subchart values settings
ui:
enabled: true
ingress:
enabled: true
hosts:
- host: "*.local" # change this to your appropriate domain
paths:
- path: /
pathType: ImplementationSpecific

Port-forwarding​

For a quick look or debugging, one can setup a port-forwarding to the service with:

kubectl port-forward service/kubewarden-controller-ui 8082:8080 -n kubewarden

Which will make the Policy Reporter UI available at http://localhost:8082.

Trigger manual run​

The audit scanner is implemented as a Cronjob that runs every 60 minutes by default. It's possible to trigger a manual run by running the following command:

kubectl create job \
--namespace kubewarden \
--from cronjob/audit-scanner \
audit-scanner-manual-$(date +%Y-%m-%d-%H-%M-%S)

The status of the job can be checked with:

kubectl get -n kubewarden jobs